John Glenn Columbus International Airport (KCMH)
Airport Information
John Glenn Columbus International Airport Pilot Reviews:
Lopez
December 14, 2024Fellow pilots , I had the opportunity to land at Columbus International Airport last Saturday. I asked for Progressive taxi instructions the control tower was extremely helpful I b...
Richard
October 24, 2022This is the class Charlie that could easily be a class Bravo. Well run and efficient.
FBOs & Fuel
Remarks
All surfaces around terminal; north of taxiway 'd' & south of taxiway ' E' are non-movement areas.
Be alert: runway 10l/28r restrictions on stage i & ii turbojet aircraft 2200-0800 & on stage iii turbojet aircraft 2200-0700. practice apchs for high noise level type aircraft including non-stage iii mil jet aircraft shall not be approved unless runway 10r/28l is in use & the approach terminates in a full stop taxi-back opn.
Birds in vicinity of airport.
Designated Customs Landing: To request landing rights contact us customs between 0730-2200 mon-fri at 614-497-1865.
Flight notification service (adcus) available.
Hold pad for runway 28l rstrd to aircraft with wingspan less than 118 ft.
Model aircraft traffic within a 1 nm rds of a point 8 nm on a 010 deg brg from the airport; surface - 5000 ft AGL; sr-ss dly.
Noise Abatement: Noise barrier located at southeast side of airfield - restricted to aircraft with wingspan less than 79´
Noise barrier located at SE side of airfield restricted to aircraft with wingspan less than 79 ft.
Pilots conducting efvs operations; be aware led als in use runway 28l.
Nearby Airports
| ID | Name | Distance |
|---|---|---|
| KOSU | Ohio State University | 10.8nm NW |
| KLCK | Rickenbacker International | 13.3nm S |
| KTZR | Bolton Field | 14nm SW |
| KLHQ | Fairfield County | 20.8nm SE |
| KDLZ | Delaware Municipal/Jim Moore Field | 22.8nm NW |
| KVTA | Licking County Regional | 23.3nm E |
| KMRT | Union County | 28.7nm NW |
| KUYF | Madison County | 29.9nm W |
| 4I3 | Knox County | 30.5nm NE |
| 6G4 | Wynkoop | 33.5nm NE |
Recent Arrivals
Recent Departures
Radio Frequencies
Airport Information
John Glenn Columbus International Airport Pilot Reviews:
Lopez
December 14, 2024Fellow pilots , I had the opportunity to land at Columbus International Airport last Saturday. I asked for Progressive taxi instructions the control tower was extremely helpful I b...
Richard
October 24, 2022This is the class Charlie that could easily be a class Bravo. Well run and efficient.
FBOs & Fuel
Runway Information
Recent Arrivals
Recent Departures
Radio Frequencies
Remarks
All surfaces around terminal; north of taxiway 'd' & south of taxiway ' E' are non-movement areas.
Be alert: runway 10l/28r restrictions on stage i & ii turbojet aircraft 2200-0800 & on stage iii turbojet aircraft 2200-0700. practice apchs for high noise level type aircraft including non-stage iii mil jet aircraft shall not be approved unless runway 10r/28l is in use & the approach terminates in a full stop taxi-back opn.
Birds in vicinity of airport.
Designated Customs Landing: To request landing rights contact us customs between 0730-2200 mon-fri at 614-497-1865.
Flight notification service (adcus) available.
Hold pad for runway 28l rstrd to aircraft with wingspan less than 118 ft.
Model aircraft traffic within a 1 nm rds of a point 8 nm on a 010 deg brg from the airport; surface - 5000 ft AGL; sr-ss dly.
Noise Abatement: Noise barrier located at southeast side of airfield - restricted to aircraft with wingspan less than 79´
Noise barrier located at SE side of airfield restricted to aircraft with wingspan less than 79 ft.
Pilots conducting efvs operations; be aware led als in use runway 28l.
Nearby Airports
| ID | Name | Distance |
|---|---|---|
| KOSU | Ohio State University | 10.8nm NW |
| KLCK | Rickenbacker International | 13.3nm S |
| KTZR | Bolton Field | 14nm SW |
| KLHQ | Fairfield County | 20.8nm SE |
| KDLZ | Delaware Municipal/Jim Moore Field | 22.8nm NW |
| KVTA | Licking County Regional | 23.3nm E |
| KMRT | Union County | 28.7nm NW |
| KUYF | Madison County | 29.9nm W |
| 4I3 | Knox County | 30.5nm NE |
| 6G4 | Wynkoop | 33.5nm NE |